Friday, May 06, 2016

Arduino Your Home & Environment: Monitoring voltage of a dc battery supply

Arduino Your Home & Environment: Monitoring voltage of a dc battery supply by Steve Spence:



Since we are involved in off grid solar power systems, we have a need to monitor battery voltage. The Arduino can do this easily with a simple voltage divider. With some simple mods, we can control loads, generators, or notifications based on battery voltage.







To read a maximum of 20vdc, R1 should be 3k ohm, R2 should be 1k ohm, and the code would be as follows:



/*

DisplayMoreThan5V sketch

prints the voltage on analog pin to the serial port

Do not connect more than 5 volts directly to an Arduino pin.

*/



const int referenceVolts = 5; // the default reference on a 5-volt board

//const float referenceVolts = 3.3; // use this for a 3.3-volt board



const int R1 = 3000; // value for a maximum voltage of 20 volts

const int R2 = 1000;

// determine by voltage divider resistors, see text

const int resistorFactor = 255 / (R2/(R1 + R2));

const int batteryPin = 0; // +V from battery is connected to analog pin 0



void setup()

{

Serial.begin(9600);

}



void loop()

{

int val = analogRead(batteryPin); // read the value from the sensor

float volts = (val / resistorFactor) * referenceVolts ; // calculate the ratio

Serial.println(volts); // print the value in volts

}